







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Bathroom Remodeling: The Fairfield Owner’s Guide
We install Schluter-system bathroom remodeling in Fairfield, and a full gut bath typically runs $9,000 – $28,000 installed, with waterproofing assemblies (Kerdi, Ditra, Kerdi-Board) priced as a line item inside that range. Same-day service applies only to emergency water intrusion, not planned remodels; scheduled work is quoted and booked. Most Fairfield owners discover the problem the same way: a soft, discolored grout line at the shower curb, a hollow thud when they tap the tile beside the drain, or a musty smell that lingers after the fan has run for twenty minutes. That’s usually a failed waterproofing layer, not the tile itself.
Key Takeaways
- A Schluter shower is a system: membrane, drain flange, band, and substrate have to match. Mixing parts is where failures start.
- Installed bathroom remodels in Fairfield run $9,000 – $28,000; small baths $5,000 – $12,000.
- Replacement costs below are written figures. The 365-Day Done Right Promise is a full-year written guarantee on completed work.
- Bradford Remodeling Co Fairfield is an independent service provider and is not affiliated with Schluter.
Which Schluter Models This Applies To

Schluter isn’t a single product, so “which model” is really “which assembly.” The four you’ll meet in a Fairfield bathroom:
- Kerdi-Shower / Kerdi-Board kits – the bonded sheet-membrane shower system, sold in tray, curb, and board form. Kits are sized to standard tray dimensions (common sizes run roughly 32×60 up to 48×72 in), so a nonstandard shower footprint means build-to-fit, not kit.
- Kerdi-Line and Kerdi-Drain – linear and center drains. The drain flange and the membrane must be the same series; a Kerdi-Drain flange with a generic linear channel is a mismatch.
- Ditra and Ditra-Heat – the uncoupling membrane for floors. Ditra-Heat adds the cable grid; the two are not interchangeable on a heated floor.
- Kerdi-Band and Kerdi-Fix – the seam band and sealant. Skipping the band at corners and curb-to-floor transitions is the single most common cause of a leak in this system.
Identify yours from the printed roll edge on the membrane, the drain’s stamped flange, or the kit box label. On the OEM-vs-equivalent question: for Schluter specifically, generics are a poor bet. The system’s warranty depends on Schluter parts being used together, and a $60 saved on band is not worth voiding the assembly. Measure the shower’s exact interior dimensions before you order – trays and linear drains are sized in inches, and a quarter-inch off means a return.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Bathroom Remodeling Is Failing
- Soft or crumbling grout at the curb and floor joint. Water is getting behind the tile at the most-stressed seam, usually because the Kerdi-Band was skipped or set short.
- Hollow tile sound around the drain. Thinset lost bond over a wet substrate. Tap lightly with a plastic tool handle – a dead thud versus a crisp click tells you a lot.
- Musty odor that returns after cleaning. Moisture is trapped in the wall cavity or under the tray, not on the surface.
- Loose or lifting shower floor tile. The tray was set on a flexing or unlevel subfloor, a common issue in older Fairfield homes with pier-and-beam or slab transitions.
- Water staining on the ceiling or wall below the shower. The membrane or drain flange has failed outright. Stop using the shower and call us.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Written Fairfield ranges for Schluter-system bathroom work, installed:
| Scope | Installed Range |
|---|---|
| Full bathroom remodel (Schluter shower assembly included) | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
What drives the number: shower footprint, whether the drain moves, tile selection, and whether the substrate is sound or needs repair. Parts and labor are quoted as separate lines so you can see the membrane, drain, and band cost apart from installation. A written price comes before any work starts – The Garrison Standard, and it’s non-negotiable. Every completed job carries the 365-Day Done Right Promise: if the work fails inside that year, we return and correct it at no charge. We also install KraftMaid, Cambria, and Silestone where the bath renovation calls for them.
DIY or Call Us?
You can safely check a few things yourself: tap for hollow tile, look at the curb seam, check the drain flange for movement, and note whether the musty smell returns. What you shouldn’t DIY is the repair. Cutting out a failed Schluter shower means removing tile without puncturing the membrane below, re-bonding Kerdi-Band correctly, and re-flashing the drain flange – all of which fail quietly and show up months later as a water stain downstairs. We can’t do a swap in a day; a shower re-waterproof involves cure time. But we can give you a written scope and price, from a background-checked, uniformed technician, with no surprise numbers at the door. Call (833) 998-3242 and a live person answers, any hour.
FAQs

How long does a Schluter shower assembly last in Fairfield? A correctly installed Kerdi system should hold 20-plus years; failures in Fairfield usually trace to skipped Kerdi-Band at seams or a tray set on an unlevel floor. Call (833) 998-3242 for an exact assessment and written quote.
Can it be repaired instead of replaced? Sometimes – isolated band or drain-flange failures can be re-waterproofed without a full tear-out. Call (833) 998-3242 and we’ll tell you honestly which applies.
How long does the swap take? A shower re-waterproofing typically runs several days including cure time; a full bath remodel runs longer. Not a same-day job. Call (833) 998-3242 for a written schedule before work begins.
How do you source the Schluter part? We don’t carry parts on a truck or stock them locally – we specify the correct series and size and order the matching membrane, drain, and band for your assembly. Call (833) 998-3242 for details.
Ready to price your Schluter bathroom project in Fairfield? Call Bradford Remodeling Co Fairfield at (833) 998-3242 for a free estimate – written price before any work starts, 365-Day Done Right Promise in writing, and a real person on the line around the clock.
Written by the team at Bradford Remodeling Co Fairfield, serving Fairfield and nearby areas.












